The Process for Pouring Silicone Mold Making

1. Preparing The surface of the original mold should be clean and smooth. If your products have thin flower patterns, and especially have porous substrates, please use a suitable mold release agent such as soapy water, detergent or Vaseline.       2. Mixing part A and part B Please weigh Part A and part Bof silicone rubber base and curing agent with mixing ratio of 100:2~5 into a clean container.  Stir the two parts thoroughly before use, then Mix Part A and Part B evenly until the curing agent completely dispersed in the silicone base. Manual or mechanical mixture can be used, but do not last much time or allow the temperature to exceed 35°C.it’s suitable to mix small quantities to ensure thorough mixture of silicone rubber base and curing agent.       Note: It is strongly recommended that entrapped air be removed in a vacuum chamber, allowing the mixture to completely expand and then collapse. After a further 1 to 2 minutes under vacuum, the mixture should be inspected and can be used if free of air bubbles. A volume increase of 3-5 times will occur on vacuum de-airing the mixture. So a suitably large container should be chosen.   3. Pouring the mixture and curing agent      Pour the mixed silicone rubber onto the original object as soon as possible, avoiding air entrapment. The catalyzed material will cure to a flexible rubber within 6 hours (or faster by different mixing ratio or room temperature), we advice you de-mold after 24 hours, it is will improve the replicate times of silicone mold.