keyword: Web Search:

News

ProductCategory

HY silicone

Your present location:HomeSilicone TechniqueOperation > Instructions for RTV-2 molding silicone rubber-Brushing cast molding operation-HongYe silicone

Instructions for RTV-2 molding silicone rubber-Brushing cast molding operation-HongYe silicone

Writer:TcoglorSource:www.szrl.net Date:2013-04-22

 

Operations

 

Step One:Take 100gof part A and add 2gof part B and mix the silicone rubber and curing agent evenly.

Notes:Moulding silicon rubber is a kind of flowing liquid and it contains two parts. Part A is a kind of white flowing liquid and part B is the curing agent. Remember to mix part A and part B evenly, otherwise the silicon rubber will be partly solidified and this will give birth to difficulties in your final operation. What’s more, the finished moulds will meet a short life. All of these will cause a waste of silicon rubber.

 

Step Two:vacuum pumping

Without exception, this step takes less than 10 minutes. Otherwise, it will cause cross linking reaction, and no more further steps will be available.

 

 

Step Three: Brushing cast moldingoperation

Brushing cast:

a.Evenly brush the mixed silicon rubber on the product which is covered with mold spray with a brush or a brush pen.

b.After the cross linking reaction (about 30 minutes), brush a second coat which can increase the tension and tear strength of the mold.

c. Cover a glass cloth on it after another 30 minutes of a second cross linking reaction, and use a brush pen or a brush to avoid any interstices.

d.Cover a third coat.

(Note:if you have high requirements for the tension and the tear strength for the mold, please repeat step c and step d.Hence, the finished silicone moulds will have a good quality and a longer life, which can help you save cost and increase production efficiency.)

 Step Four: Operations for the external mold

a. Make a square frame with four pieces of wooden boards or rubber plates, then place the product which is covered with the finished silicon rubber mould in the middle.

b. Slowly and evenly perfuse the gypsum into the square frame.

LINK MOLDING SILICONE RUBBER

SERVICE TEL: 86-755-89948019    86-755-89948006    86-755-89948294

 

TypeInfo: Operation

Keywords for the information:silicone mold  Silicone rubber mold  silicon mold 

Related information for reference